Car Jumper Battery Pack Jump Starter 12v 24v 10ah For Electric Vehicles

Short Description:

12V/24V10AH

Product name: Portable Jump Starter

Cell Type: High-rate 10A

Strings: 8

Protection Board: 400A Specialized

Battery Type: Lithium Iron Phosphate (LiFePO₄)

Rated Voltage: 25.6 V

Charging Efficiency: >92%

Internal Resistance: <100 mΩ

Cycle Life: >2000 cycles

Continuous Discharge Current: 400 A

Peak Discharge Current: 600 A - 10 sec

Protection Level: IP54

Short Circuit Protection: 800 A - 500 μs

Low Voltage Protection: 20 V - 5 sec (2.5 V per cell)

Self-discharge: 2.5%

Continuous Charging Current: ≤ 10 A

Disconnection Charging Current: 20 A - 5 sec

Recommended Charging Voltage: 28 V

High Voltage Cut-off: 29.2 V

Charging Temperature: (0°C to 55°C)

Discharging Temperature: (-30°C to 65°C)

Operating Humidity: <90% RH

Storage Temperature: (-20°C to 35°C)

Storage Humidity: 25% to 85% RH

Get Price Download as PDF WhatsApp

Product Detail

Product Details

Company Introduction

Factory Display

Package & Delivery

Product Tags

Operation Instructions:
Before the first use,it is recommended to charge the Voltup car Jump Starter.This can typically be done using the included charger,with a charging time of approximately 4-5 hours. Once fully charged,it can be stored for along period.
When using the Voltup Car Jump Starter,make sure to connect the power cables correctly to avoid short circuits or reverse polarity.
Avoid water or damp environments during charging and use to prevent accidents.
Regularly check the battery level to ensure it is adequately charged.

Power On and Off
Turn on the power switch;the power indicator light will illuminate.You can charge electronic devices by plugging them into the charging port only when the power switch is on. Charging
electronic devices is not possible when the power is off.

Charging Methods
Charging Method One
1.Insert the provided 15V/1.5A travel charger into the charging socket(100-240V).
2.Plug the DC connector of the travel chargerinto the DC input port of the jump starter(12V).

Charging Method Two:
1.Insert the input of the car charger into the cigarette lighter socket in the vehicle.
2.Plug the DC connector of the car charger into the DC input port of the jump starter(12V).
Note:During charging using either of the above methods,the power indicator light will flash continuously,indicating that charging is in progress.When fully charged,the power indicator lightwill remain solid without flashing,indicating a full charge.Charging time is approximately 4-5 hoursto complete a full charge.

Starting a 12V Car
When a car fails to start,you can use the Voltup car Jump Starter to start it.
1.Ensure that at least 2 or more power indicator lights on the jump starters are illuminated.
2.Attach the red battery clamp to the positive terminal (+of the battery and the black battery clamp to the negative terminal (-)of the battery.
3.Insert the battery connecting cable into the EC5 car start dedicated output port of the jump starter(12V).
4.Turn the car ignition switch to the start(START)position.
5.After the car starts,immediately unplug the plug and remove the battery clamps.
Note: After the car starts,unplug the ignition plug within 30 seconds,or a safety incident may occur. The car starting clamps are equipped with reverse protection devices.

Charging Mobile Phones/Tablets and Other Electronic Devices
1.Choose the provided USB cable or other suitable connecting cable.
2.Insert the USB plug ofthe connecting cable into the USB 5V output port ofthe main unit.